客服熱線:
廠家庫
13545068882
首頁>供應庫>印刷包裝紙張>制漿造紙設備>水分測定儀>ZXK-200紙張吸水率測定儀

單產品價格:

廠家庫編號:

  • 面議

    CJK-2248

薛晴
13545068882 027-86619996
  • 發貨地  湖北 武漢市
有效期至長期有效 最后更新2019-06-07 07:19
瀏覽次數2994
ZXK-200型紙張吸水率測定儀產品使用說明書

一、型號含義及生產依據
A, model meaning and production basis
本儀器根據QB/T1662《克列姆吸收性測定儀》所規定的各項技術參數和技術要求生產的。
The instrument according to the requirements specified in the QB/T1662 absorption tester for "Klemm" of the technical parameters and production technique.
型號含義:
ZXK-200紙張吸水率測定儀
Type meaning:
Z XK 200
Z XK 200
最大吸水高度(mm)
The maximum height (mm)
吸水率
Water absorption rate
紙張試驗機
Paper testing machine
二、用途及使用范圍
Two, the use and the use scope
本儀器適用于未施膠的紙和紙板毛細吸液高度的測定。(不適于10min內毛細高度小于5mm的紙和紙板)。
The utility model is suitable for the unsized paper and board Determination of capillary rise. (not suitable for 10min capillary height less than 5mm of paper and cardboard).
三、主要技術參數
Three, the main technical parameters
1、測量范圍:5-200mm
1, measurement range: 5-200mm
2、試樣尺寸:250x15mm
2, the sample size: 250x15mm
3、刻尺分度值:1mm
3, scale division value: 1mm
4、同時測定試樣數量:10條
Simultaneous determination of 4, the number of samples: 10
5、刻尺數量:5
5, scale quantity: 5
四、儀器結構
Four, the structure of the instrument
儀器由底座、支柱、橫梁、橫板、刻尺、手柄及水槽組成(見圖1)轉動手柄起動偏心機構使橫梁帶動橫板及刻尺平穩上升或下降。
The instrument is composed of a base, a pillar, beam, plate, scale, handle and a water tank (see Figure 1) to rotate the handle starting eccentric mechanism to drive plate and beam scale steady rise or fall.
五、操作步驟
Five, operation steps
1、轉動偏心手柄使刻尺降到最低位置。
1, the rotation of the eccentric handle to scale down to the lowest position.
2、在水槽中注入適量的水,使所有刻尺的零點接觸水面,通過調節支足來實現。
2, in the sink into the amount of water, so that all the scale of zero contact surface, is realized by adjusting the supporting foot.
3、轉動手柄將刻尺升到最高位置。
3, turn the handle will scale up to the highest position.
4、平放試樣,在距試樣一端205mm處劃一條與長度方向垂直的直線,然后將10條試樣夾在橫
4, flat specimen, in a straight line from the sample is 205mm and the length of a vertical direction, and then the 10 specimens caught in the cross
板上刻尺的兩側,所劃橫線應與刻尺200mm刻線對齊。
On both sides of the plate scale, the underline and scale 200mm reticle alignment.
5、轉動偏心手柄使刻尺降至最低位置,此時各刻尺零點剛好接觸水面,而試樣則深入水中5mm這時按動秒表計時,從而測定出試樣毛細吸液的一定高度所需時間或一定時間內試樣毛細吸液的高度值。一般采用10min±3s內的吸液高度,用s/mm或mm/s表示。
5, the rotation of the eccentric handle to scale to the lowest position, the scale zero just contact surface, and the samples into the water when the 5mm stopwatch, which measured a certain height sample capillary imbibition time required or within a certain period of time the sample capillary liquid absorbing height. Generally use the 10min ± 3S within the liquid height, denoted by s/mm or mm/s.
6、在讀取數字時準確至1mm。如吸液潤濕線傾斜或彎曲,應按平均高度讀取結果。
6, in reading numbers to 1mm. Such as liquid wetting line inclined or curved, should read the results according to the average height.
7、深入液體中的試樣長度,可按產品標準或其它要求適當延長,但要在試驗報告中注明。
The length of specimen 7, deep in the liquid, can according to product standards or other requirements appropriately extended, but be noted in the test report.
六、儀器的檢驗
Six, test instrument
1、刻尺與橫板應處于垂直位置。
1, scale and the transverse board should be in a vertical position.
2、五條刻尺的零點應位于同一水平線上。
2, five minute scale zero should be located on the same horizontal line.
3、偏心輪升、降機構應靈活,操作輕松。
3, an eccentric wheel rise, delet mechanism should be flexible, easy operation.
4、試樣夾子應保持牢固地夾緊試樣
4, the specimen should be firmly clamped specimens
七、保養
Seven, maintenance
1、保持儀器清潔,測試結束后應擦凈加罩。
1, keep equipment clean, after the test should be cleaned with cover.
2、軸、套之間、定位鍵與槽之間定期注入潤滑油。
2, shaft, sleeve, positioning key and the groove between the injected regularly into the lubricating oil.



裝 箱 單

編號: 0 6 2
產品型號: Z X K— 200
產品名稱: 紙張吸水率測定儀

序號 名 稱 單位 數量 備注
1 主 機 臺 1
2 水 盤 個 1
3 產品說明書 本 1
4 合 格 證 份 1
全網同類推薦

為您推薦

免責聲明:
當前頁為ZXK-200紙張吸水率測定儀價格信息展示,該頁所展示的ZXK-200紙張吸水率測定儀批發價格、ZXK-200紙張吸水率測定儀報價等相關信息均有企業自行提供,ZXK-200紙張吸水率測定儀價格真實性、準確性、合法性由店鋪所有企業完全負責。廠家庫對此不承擔任何保證責任。
友情提醒:
建議您通過撥打ZXK-200紙張吸水率測定儀廠家聯系方式確認最終價格,并索要ZXK-200紙張吸水率測定儀樣品確認產品質量。如ZXK-200紙張吸水率測定儀報價過低,可能為虛假信息,請確認ZXK-200紙張吸水率測定儀報價真實性,謹防上當受騙。
 
广西快3网上投注